Cut Lid or Bottom Cut a six-sided lid, big enough so you can reach in and clean out all the pumpkin gunk. Angle the Lid CutterTM Saw or a knife towards the center of the pumpkin to create a ledge that supports the lid.
	Clean and Scrape Using the Pumpkin Masters patented Scraper ScoopTM (or a flat-edged ice cream scoop), clean out the seeds and strings. Where you plan to carve, scrape the pumpkin wall until it's about one inch thick.
	Attach Pattern Tape or pin the pattern to your pumpkin. If you use pins, place them on the design lines so you don't end up with holes you don't want!
	Transfer Design Using Pumpkin Masters poker tool or a push pin, make pinpoint marks 1/16" to 1/8" apart along the design lines. Check to see you have transferred the design completely, then tear the pattern off the pumpkin.
	"Saw" Design Using Pumpkin Masters slender carving saws, saw dot-to-dot using a gentle up and down motion. Easy does it, Pumpkin Picassos!

Return to Pumpkin Masters Products Page

Visit Pumpkin Masters' Web Site

We're pleased to announce the Grand Opening of our newest web site, Yankee Halloween. Devoted exclusively to one of our favorite holidays, you'll find the complete line of Pumpkin Masters products plus more great Halloween products in our Graveside Store.

So much fun it's scary! Click here to visit Yankee Halloween today!

Return to Yankee Harvest Country Store

Please visit our other web sites:

Web Site Policies | Terms and Conditions

If you experience any problems with this site, please email webmaster@yankeeharvest.com